Current Pet Fountain Set Up
Table of Contents
Welcome
Welcome to your new PetSafe® Current Pet Fountain.
Keep in Mind
The acclimation time may vary with each pet.
The sound of moving water triggers instinctual behavior to drink more.
The circulating water prevents mineral build up.
The filtration system forces water through a carbon filter that removes particles, bad tastes and odors.
The fountain will need to be cleaned before first use.
Preparation: Materials
Have the following contents from the box ready prior to set up:
Bowl
Lid
Pump Plate
Carbon Filter
Pump
Power Adaptor
Clean the Fountain
Clean the fountain once a month. Multi-pet households may need to clean every two weeks.
Wash all parts of the fountain using unscented soap, warm water and a small brush before first use.
Disassemble and scrub the pump.
Disassemble the Fountain
Remove the lid by pulling up on the tab in the back.
Slide the pump plate up and out.
Disassemble the Pump
Note: Place the pump parts in a safe place to avoid dropping them down the drain.
Use a tool with a small, flat edge to remove the intake plate on the end opposite of the cord.
Pull up on the small lip to remove the stator.
Remove the impeller by pulling up from underneath the white disk.
Note: The impeller is held in place by a magnet. This may give some resistance when trying to remove.
Clean all parts of the pump with unscented soap and warm water.
Reassemble the Pump
Place the impeller, stator, and faceplate back onto the base to reassemble the pump.
Rinse the Filter
Note: The carbon is made from coconut shells and is safe for your pet.
Rinse the carbon filter under warm water for 30 seconds before use. Loose black particles may rinse out from the filter and could be seen in the bowl if the filter is not rinsed thoroughly.
Reassemble the Fountain
Attach the pump plate to the pump. Make sure that the tab on the plate lines up with the edge of the pump.
Slide the plate and attached pump into the slots inside the bowl. Press down to secure.
Feed the cord through the opening in the center of the bowl.
Pull the cord snug, press into the channel on the bottom of the bowl and align with the notch.
Insert the carbon filter between the slots next to the pump. The black side of the filter will face the pump.
Place the fountain in the desired area and fill with water. Leave at least 1/4 inch between the water level and the lip of the bowl.
Align the lid and press down to secure. A snap will be heard.
Connect the pump cord to the power adapter and plug into a standard electrical outlet.
Acclimate Your Pet
If your pet is hesitant, try the tips below to help your pet get accustomed to their new fountain.
Don’t plug in the fountain for the first few days. Your pet may be intimidated by the running water.
Add a small amount of broth to the water to help attract your pet to the fountain.
Contact Customer Care
If you need further assistance, please contact our customer care team.