Set Up the Remote Spray Trainer
Table of Contents
Welcome
A Few Things To Keep In Mind:
The initial charge time will be five hours.
The amount of training time needed will vary with each dog.
Refrain from having your dog wear the collar for longer than 12 hours to avoid skin irritation.
The trainer is intended for dogs six months and older.
Step 1: Preparation
Charging
Before the first use, fully charge the remote and collar for five hours by following the instructions below. Every charge after will take 2-3 hours.
Note: The battery life can last up to 40 hours depending on use. Turning off the collar between use will extend the battery life.
Lift the rubber covers protecting the charging ports on the remote and collar.
Connect the charging connectors to the ports on the remote and collar.
Plug the adapter into a standard electrical outlet. The collar light will turn green and the remote battery icon will cycle to show charging.
Unplug once there is no light on the collar and the battery status icon on the remote is full.
Reposition the rubber covers over the ports when charging is complete. The system remains waterproof even without the rubber cover.
Important: Excessive charging can shorten battery life. Only charge the remote or collar when the batteries are low.
Insert Spray Cartridge
The collar includes two spray cartridges in unscented and citronella scent.
Locate the cartridge holder at the bottom of the collar. Pull back on the tab to release the door.
Place the cartridge into the cartridge holder.
Close the cartridge door and re-latch. A click will be heard to confirm the door is properly closed.
Step 2: Pair Your Collars
Pair Dog 1
The collar needs to be turned off before it can be paired. Confirm it is turned off by checking that the light indicator is not flashing.
Press and hold the power button on the collar for five seconds. The light will turn solid green, then go out. Release the button when the light goes out.
Note: The light can be hard to see when holding the button on the collar. Press the button on an angle to see the upper half of the button while holding.
Press and hold the upper left button on the remote to pair the collar.
The collar will flash five times and then begin beeping to confirm it is paired. Release the button and test to confirm it is properly paired.
Pair Dog 2
Press the button on the right side of the remote to switch to dog 2. Repeat the steps above to pair the second collar.
Step 3: Test Your Collar
Test Spray
Press the up or down button to set your remote on level S.
Hold the collar away from your face and press the upper right button.
Spray will emit from the collar.
Test Vibration
Use the buttons on the left to set the remote to level 0, then hold the upper right button. The remote will show V to indicate a vibration is being sent and the collar will vibrate.
Test Tone
Press and release the upper left button on the remote. The remote will show T to indicate a tone is being sent and the collar will tone.
Step 4: Fit Your Collar
Fit Strap
Center the collar on your dog’s neck while the dog is standing.
Check that one finger fits between the probe and your dog’s neck.
Note: For long haired pets it may be necessary to trim their neck hairs to ensure proper spray pattern.
Adjust Strap
Fasten buckle
Slide buckle
To Loosen
Move the strap through the slide buckle, fasten the buckles and then pull down.
To Tighten
Move the strap up through the fasten buckle, then pull through the slide buckle.
Trim Strap
Place the collar on your dog, and mark the strap at least two inches past the slide buckle.
Note: Leave strap longer for dogs that grow a thick winter coat and puppies who are still growing.
Remove the collar and cut at the mark.
Apply a flame to the cut edge to seal the end of the strap.
Contact Customer Care
If you need further assistance, please contact our customer care team.